Change my secondaries from stock to 1200cc.. What should i do on the microtech to get it run before i go to the dyno?

will i run at all with the map I'm using now? Since its not using the secondaries at idle.. will the problem first come up when i start reving and gets load on the engine?

 

Engine will run fine.

It will just be bad to drive when you put your foot down.

If you drive it very slowly to your dyno operator you will be fine.

 

What do i do in the ecu to make it run good on load as well then?
nice to know, even though i'm gonna take the car to the dyno.