Microtech Adding an additional injector
#1
Senior Member
Thread Starter
Join Date: Nov 2001
Location: Spearfish, SD
Posts: 725
Likes: 0
Received 0 Likes
on
0 Posts
Adding an additional injector
I have a water injection system that I am trying to use a fuel injector to spray water with. I want the additional injector to pulse with my secondaries, that way whenever the secondaries come on (under boost) my water injection will too. I have the pump set to come on at 1 psi w/ the aux out. and the secondaries to stage at 2 psi. I tried adding my additional injector in parallel with one of my secondaries and it wouldnt work, the secondary also wouldnt fire. I unplugged the extra injector, and the secondary started firing fine. am I overloading the secondary injector bank or what? Ill measure the resistence and see where im at. Should I not wire it in parallel? Any advice?
#2
Senior Member
Thread Starter
Join Date: Nov 2001
Location: Spearfish, SD
Posts: 725
Likes: 0
Received 0 Likes
on
0 Posts
Well it turns out that it was a bad injector, that part of the system works fine now. Im now having a problem with the aux out on the microtech. It is a switched ground right? It shows 0v whether it is switched on or off. So I dont know whats going on.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM