Megasquirt quick question on wideband
MegaSquirt Mod
Joined: Sep 2004
Posts: 4,721
Likes: 1
From: Maryland
The wideband has nothing to do with the daughtercard.
Just wire the wideband controller's 0-5v output to the MS's O2 input, and make sure the MS and wideband are grounded in the same place.
Ken
Just wire the wideband controller's 0-5v output to the MS's O2 input, and make sure the MS and wideband are grounded in the same place.
Ken
Full Member
Joined: Feb 2009
Posts: 140
Likes: 0
From: Europe
Hi,
try to look at this PDF PAGE 6, maybe it will help you http://stuff.pw.cx/Megasquirt%20MS2%...azda%20CAS.pdf
As i remember wideband need a controler, the PDF shows direct power from 12V (for some types i think it will work), if your WB already have that controler you just need to use the outup and feed it to pin 23.
I hope it help
(ops,,, post almost at same time as Ken)
try to look at this PDF PAGE 6, maybe it will help you http://stuff.pw.cx/Megasquirt%20MS2%...azda%20CAS.pdf
As i remember wideband need a controler, the PDF shows direct power from 12V (for some types i think it will work), if your WB already have that controler you just need to use the outup and feed it to pin 23.
I hope it help
(ops,,, post almost at same time as Ken)
Last edited by RX-S7V7N; Sep 28, 2009 at 08:13 PM.
Thread
Thread Starter
Forum
Replies
Last Post
SakeBomb Garage
Group Buy & Product Dev. FD RX-7
8
Oct 9, 2015 10:05 PM
Nosferatu
2nd Generation Specific (1986-1992)
7
Sep 5, 2015 02:13 PM