hello, well i assemled the power supply... and accodring to the v3.0 assembley manual, i should plug in the stimulator and should start testing certain pins voltage, on the 40-pin SOCKET, so i did, by the manual, the voltimeter should read about 4.9-5.1 volts... i got around ~5.40... is this a concern????

thank you

 

Go to msefi.com and post. Yours is a general build question.

 

Yeah i agree with you... but i'm having problems logging to thier site (network wise), but anyway... if any body can help they are welcome

 

FINALLY i figured what the problem was... it was a matter of an inaccurate voltimeter thats it!!!
borrowed another one from a friend and tested... and it red right where i wanted it to read... 5.1 volts!!!