Megasquirt MS3 question
Thread Starter
Joined: Dec 2008
Posts: 80
Likes: 0
From: weatherford, Tx
MS3 question
I would like to upgrade my MS2 3.0 to the new MS3 and MS3X. However I was wondering if anyone would know how far back to stock does the board have to go and what components need to be addressed?
Example. I bought my ecu used and the previous owner removed R13, C11, and Q20. there is also 3 wires going to the LEDs from SPR 2, 3, and 4. I assume as coil drivers. Can the board be used as is or do I have to remove the wires and reinstall the components?
Example. I bought my ecu used and the previous owner removed R13, C11, and Q20. there is also 3 wires going to the LEDs from SPR 2, 3, and 4. I assume as coil drivers. Can the board be used as is or do I have to remove the wires and reinstall the components?
Thread
Thread Starter
Forum
Replies
Last Post
Adaptronic S5 Turbo PNP Unit questions
_Tones_
Adaptronic Engine Mgmt - AUS
10
May 25, 2021 05:37 AM
Nosferatu
2nd Generation Specific (1986-1992)
7
Sep 5, 2015 02:13 PM