Was curious if anyone had a MS3-Pro sample project they could send me to play with the software some more?

I have been trying to setup a faux-MSQ for my FD, but am getting stuck when selecting some inputs because the MS3 sample project inputs don't match the pinout names, etc from for MS3-Pro user manual. I would just rather them say "Analog input 1" or "Digital frequency in 1" instead of things like "JS10" or "PT2."

If this isn't possible, is there a cross-reference chart available anywhere?

 

Think I found what I was looking for, but I'm not sure yet because I don't have access to my tuning laptop right now.

In the latest MS3 firmware (found here: Megasquirt Downloads), there is a MS3-Pro config file that shows names like "Analog 3" and others. So I'll just try to load that config file in place of the standard MS3 config file later tonight and see what happens.

 

So this method works just fine. Also, diyautotune sent me the standard MS3-Pro msq file, so if anyone else wants to try out the software with the correct MS3-Pro config and msq files here's how (if you are running Windows).

- Download and install TunerStudio from EFI Analytics (Link)
- Download the zip files attached to this post
- Copy the ms3pro.ini config file to C:\Program Files\EFIAnalytics\TunerStudioMS\config\ecuDef (might be "Program Files (x86)" if running a 64-bit system)
- Open TunerStudio and start a new project (File->Project->New Project or Ctrl+N)
- Name the project and under "ECU Definition" click the box that says "Other" then click "Browse" and find the config file that was just copied
- Finish creating the project, selecting whatever options you like
- Copy the default-ms3pro-1.2.1.msq map file to My Documents\TunerStudioProjects\"Name of new project"
- In TunerStudio go to File->Open Tune and select the MS3-Pro .msq map file you just copied
- Everything should be good to go where you can select the actual inputs/outputs for the MS3-Pro