Well have Megasquirt V3.0, I was going to use it on another project i had but I was wondering if its possible to install this board into the 93 rx7? has it been done? If so where can i find the link to the instrucions and all that stuff?

 

Wow i've been searching for a while but i don't find info of megasquirt on a 93 and up only find info for the fc's

 

I know it's possible and it's more commonly installed on the 2nd gen but i'm sure there is a way. The only thing different is the crank angle sensor and the coil packs. There is an option in the megatune software to use 3rd gen cas and coil packs.

 

well after more researching found this link...

https://www.rx7club.com/megasquirt-forum-153/squirted-fd-project-459133/

 

As far as I know, nobody has tried to do anything with it since the last post in that thread.

 

Hi guys,
i've bumped the other thread as well. I'm coming at this as a novice and trying to find out if its worth my while researching and installing megasquirt on my FD? is it just a case of no one getting around to doing it or are there particular problems to be overcome that would cause too much trouble to a newbie engine management builder?