Megasquirt An ignition question
Thread Starter
Full Member
Joined: Sep 2001
Posts: 133
Likes: 0
From: Illinois
An ignition question
So if I follow all the instructions in the FAQ to wire my rotary's ignition up to a MS1 v3, could I use the dual coil pack at the link listed below to replace the leading coil in my car?
http://www.tejasthumpcycles.com/Part...coil_16071.jpg
http://www.tejasthumpcycles.com/Part...coil_16071.jpg
MegaSquirt Mod
Joined: Sep 2004
Posts: 4,721
Likes: 1
From: Maryland
You would need to have something to actually charge the coil...
I don't really know anything about that coil either... I guess if you drove it with a crane ignition module it would work.
Why do you need that coil anyway? The stock 2nd gen coil/ignitor produces a VERY good spark, even with pretty low dwell.
Ken
I don't really know anything about that coil either... I guess if you drove it with a crane ignition module it would work.
Why do you need that coil anyway? The stock 2nd gen coil/ignitor produces a VERY good spark, even with pretty low dwell.
Ken
Thread
Thread Starter
Forum
Replies
Last Post
SakeBomb Garage
SakeBomb Garage
0
Sep 4, 2015 05:20 PM
SakeBomb Garage
Vendor Classifieds
0
Sep 4, 2015 05:19 PM