Okay so I am looking into picking up the FFE Hall effect trigger kit. I have read that the stock CAS can change up to 10* of timing due to the slight slop in the gear system and it seems pretty bad especially on a high performance engine...

SO! my question is:

Can the Zeal board be removed along with the 4 stranded cas wire? I know I had each 4 wires running to separate leads on the board. Now the hall effect has power, ground and a 5v signal. I could repurpose the wire since its shielded, but I assume it gets wired into a different spot as well. Can anyone explain???

 

Maybe I should rephrase. I assume the zeal board can be removed as well as the 4 shielded wire. Can someone confirm this?

Then, I run a power, ground and shielded 5v wire....where does this get sent into the ECU?

 

guess I should have read before posting...for anyone else curious, the zeal board can be removed. here is how the hall sensor gets wired up.



FFE provides tunerstudio ignition setup on their website.

 

I am running the ffe kit on my car. One of the best mod I have done . Fixed a lot of issues with tach signal. And made thing simpler.