Heyo,

I'm just finally getting around to installing Error's daughterboard, which I built up quite a while and two moves ago... I seem to have lost my installation instructions to my v2.2 board, does anyone have them handy? I found Muy's instructions for the CAS connections, but I'd like the pin outs for the rest of the features as well...

Also, is there a way to use this with the relay board (v1.1)? I really liked the convience of only running the wires to the board, then one big connector from the relay to the main board....

Thanks!

 

Okay... Even though I searched for a few hours before posting this question up, more searching revealed the answer to me... In case anyone else runs across this problem, I'm attaching Error's list of connectors so now it will be referenced in two places.

Also, there's no way to run the CAS through the relay board, so you would still need to run a wire down to the MS unit anyway...