my motor came with extra injectors .....i was lookin at the greddy rebics and hks AIC but MS i know i can find the information i need to get it working

can i run MS to just control my extra injectors , get it to come on at a certain rpm or boost level

 

Yes. Rather easily.

The easiest method is to just set the 'Squirt to stage and then connect the additional injectors to the second injector driver. Then set you stage point to bring them in as appropriate.

 

As Aaron says it should be fairly easy. Add coil input(rpm), a map sensor and a IAT to the MS and you have a ultra slick add. inj. controller that is temp. compensated. If you look at the MS official forum there is info on how to share sensors(map, IAT,etc.).You also need the correct firmware code loaded that has true "zero" pulse rate ,as some code varients will still inject a min. amount when unused fueling bins are set to zero IIRC.

 

thanks guys....is there any sense gettin the v3 board or would the ms1 v.2.2 work fine

 

If you plan to use it as a stand alone FI unit down the road, then you are better off with a V3.The V3 board has one VR circuit built in making it easier and neater to convert the ignition to work along with additional spare pins on the DB37(main connector) available.Otherwise there's nothing wrong with a V2.2.