I was wondering if anyone had any tips, prices or anything like that because I'm thinking about a megasquirt ecu to help run a bov setup and tune my TII. If anyone has done this or is in the process of doing so a little feedback would be appreciatied!

 

Check DIY autotune.

http://diyautotune.com/

 

There's a whole section dedicated to it: https://www.rx7club.com/forumdisplay.php?f=153

 

I built one about a year ago and installed it back in the summer to run my newley rebuilt TII. As long as you are good at following instructions you won't have any problems. Make sure you have a good soldering iron, they say a 15 watt will do it but I used a 20/40 watt iron and I had it on 40 most of the time. just be carefull not to overheat anything and inspect each solder carefully shortly after you make it. You can P/M me if you have any specific questions.

 

Yeah, definitely check out the MegaSquirt section on the forum.

Did you have any specific thing about the MegaSquirt you were wondering about?

 

No nothin really specific. I was jus kinda wondering about it and wether or not it would make a huge difference if i was only looking to be pushing around 250hp

 

it doesn't matter how much power you're going to be going for, it'll make sure the timing and fuel are where you set them.

Ken