Description:

***13b Rew engine and transmission for sale***

Includes



 

 Engine rebuild by IRP

Resurfaced rotor housing with RX apex seals

Stage 3 large aggressive street port

Turblown engine studs

Banzai oil brace

Custom LMS-EFI engine wire harness

IRP stainless oil filler neck

IRP manifold and down pipe

IRP high flow water pump

Gt4088 r turbo with rebuilt CHRA

Hks ssq BOV

Tial waste gate

FFE Fuel rail with competition set up with AN fittings and braided lines

FFE Fuel pressure regulator

Bosh ev14 725/2000cc injectors

Sake bomb IGN-1A ignition marine coil kit with mounting bracket

Racing beat single exhaust with full exhaust system from down pipe to exhaust

Greddy elbow

Apexi power fc ECU

KOYO radiator 

rx8 cooling fans

Greddy Front mount intercooler “ with plumbing”

Cube racing short shifter

 Oil Catch can

Air separation tank

FD transmission

Act clutch

Bee R* 2 step rev limiter

RX8 starter rebuild with FD starter housing. 



 

 

 ** Reason for selling was going to going to stud the motor and go with a bigger fuel set up with my cd009 transmission but acquired a 20b so I will not be using my 13b.  I did not stud the motor or put the banzai oil brace on so whoever purchases this set up will have to do it but have the parts brand new.  Everything is in working condition was looked by JPR imports and tuned by JPR 2 years ago and did not even put 1,000 miles since then. 



 PROs

Basically it’s a drop in set up with just a few minor things you will need to add.

Has a custom LMI –EFI engine wire harness plug and play

Power FC with Controller and mounting bracket

Fuel rail, injectors, AN fitting and lines are already on.

Sakebomb ignition kit

No exhaust needed comes with 3 inch full exhaust from downpipe to exhaust to racing beat exhaust muffler

A lot of expensive aftermarket parts included with sale.



 Cons*

5 gear has a grind had it when I bought the car so to get into 5th you need to double clutch to go into 5th gear.  * would recommend getting rebuilt while the transmission is out *

Intercooler and radiator work perfectly fine just visual isn’t perfect looking along with the plumbing.

Greddy elbow has an adaptor for my meth kit  “not included in sale” so if you do not run a meth kit you will need to weld the little hole.

Catch can air breather needs to be replace its like 10 bucks for a replacement filter. 

Intercooler brackets broke off the sides needs new brackets.



 I will be as transparent as possible if you need additional pictures or questions feel free to msg me and please no tire kickers or people who want to talk bad about the price or anything negative just to get a kick out of just being a D!ck.  I’m sure most of us here are adults who can keep a clean conversation with no bashing.   



 LJ Lee
(215) 966 9665
***local pick up only***