Description:

A used AEM peak and hold injector driver"The AEM 10 Channel Peak & Hold Injector drivers contains 10 independent injector drive channels. It’s typical function is to allow full battery voltage to fuel injectors for rapid current rise, in order to produce positive injector opening. When load current reaches 4.1A, the injector driver reduces the load current to 1.1A and operates as a constant current sink. This condition holds the injector open and reduces system power dissipation. If the current fails to reach 4.1A within 5mS, the driver module automatically limits the load current to 1.1A.

NOTE: It is strongly recommended that you have a wiring diagram for your specific vehicle before attempting to install the AEM P&H driver module.

TECHNICAL FEATURES

Operating Voltage: 8-18 volts, negative ground

RPM Capability: Unlimited

Injector Triggers: 10

Trigger Waveform: Output is activated when trigger is grounded

Trigger Impedance: 220 Ohm input impedance, pulled to 12V (60 mA draw)

Injector Outputs: 10

Output Current High: 4.15A Peak, Typical

Output Current Low: 1.15A Sustain, Typical

Peak Current Timeout: 5mS

Size: 5.5"L x 4.6"W x 1.4"H

Weight: 2.7 Lbs

Over Temp Shutdown: 115C (Nominal)"

Thanks