Rafael from Anaheim, California.
#1
Can Post Only in New Member Section
Thread Starter
Join Date: Jun 2015
Location: Anaheim, California
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Rafael from Anaheim, California.
Hi I'm Rafael, I bought a 1983 rx7 and don't completely understand rotaries but this site has helped a lot so far. What I do understand thought is that my car is a blast to drive . I eventually want to build this car into a speedy, neck breaking, daily driver.
#3
Junior Member
Join Date: May 2015
Location: Garden Grove
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Hi,
I'm new to the forum as well. I'm in Garden Grove.
Not sure if it's possible to have a speedy, neck breaking RX7 as a daily, but I guess that's subjective. Good luck.
I'm new to the forum as well. I'm in Garden Grove.
Not sure if it's possible to have a speedy, neck breaking RX7 as a daily, but I guess that's subjective. Good luck.
#4
Can Post Only in New Member Section
Thread Starter
Join Date: Jun 2015
Location: Anaheim, California
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
So far I have full exhaust done and I'm on a 45 weber. I'm planning on upgrading to an RB 48IDA in about a month or so and to upgrade my fuel pump/regulator but I've got some more reading to do still. Hopefully that'll bump me close to 150 flywheel?
I'd like to hit low 14s but I don't think that's possible on a stock port
I'd like to hit low 14s but I don't think that's possible on a stock port
Thread
Thread Starter
Forum
Replies
Last Post