New to the Site
Thread Starter
FABRICating your interior
Joined: Jan 2009
Posts: 51
Likes: 0
From: Colorado
New to the Site
Hello I'm new to the site.
I just picked up a 1984 RX-7 to use as a daily while i do a major rebuild on my civic.
Right now plans are to just do a few odds and ends to clean it up. I'm going to be sanding it down and respraying it when time allows.
It has a side draft carb, aftermarket intake manifold and header. I'm not sure what brands. I havent looked into it yet. It has disk brakes and i believe and LSD altho i havent checked.
Well thats about it. I'm very new to rotary motors and the rx7 as I am typically a Honda guy but I'm really looking forward to learning more.
On to a few pictures
picture of the intake manifold and header
I just picked up a 1984 RX-7 to use as a daily while i do a major rebuild on my civic.
Right now plans are to just do a few odds and ends to clean it up. I'm going to be sanding it down and respraying it when time allows.
It has a side draft carb, aftermarket intake manifold and header. I'm not sure what brands. I havent looked into it yet. It has disk brakes and i believe and LSD altho i havent checked.
Well thats about it. I'm very new to rotary motors and the rx7 as I am typically a Honda guy but I'm really looking forward to learning more.
On to a few pictures
picture of the intake manifold and header
Thread
Thread Starter
Forum
Replies
Last Post
renjiv2
3rd Generation Specific (1993-2002)
57
Jan 25, 2024 03:34 AM