New to rotary, 13B with a draw through turbo
09-07-17, 04:53 PM
#1
Can Post Only in New Member Section
Thread Starter
New to rotary, 13B with a draw through turbo
I am new to the site, new to rotary, and new to turbo's.....
I bought a 13B with 90k on it when it was pulled and a partial draw through turbo setup.
The turbo is from a Buick T type so it's setup for a draw through, the intake is 90% but needs some attention and to be machined flat. The turbo is mounted, the exhaust to the turbo is 90% and there is a Quadrajet carb mounted up.
The intention of the setup is to go into my 1956 VW bug, the setup was being built for a bug so it will all fit but there is a fair amount of work to be done.
I am in the process of building a car for my wife so this is a part time project for the near future but I need to get to know rotary engines, turbo's and draw through carbs as well as finish the fab of a few parts and source or fab a few others such as the injector plugs.
I will post up some pictures of the setup in the next week or so when I get it all sorted out.
I bought a 13B with 90k on it when it was pulled and a partial draw through turbo setup.
The turbo is from a Buick T type so it's setup for a draw through, the intake is 90% but needs some attention and to be machined flat. The turbo is mounted, the exhaust to the turbo is 90% and there is a Quadrajet carb mounted up.
The intention of the setup is to go into my 1956 VW bug, the setup was being built for a bug so it will all fit but there is a fair amount of work to be done.
I am in the process of building a car for my wife so this is a part time project for the near future but I need to get to know rotary engines, turbo's and draw through carbs as well as finish the fab of a few parts and source or fab a few others such as the injector plugs.
I will post up some pictures of the setup in the next week or so when I get it all sorted out.
The following users liked this post:
revchux (10-05-17)