New Member from Aruba .
#1
aruba fd 1995
Thread Starter
New Member from Aruba .
Hi, my name is Brian i'm from Aruba
I'm a licensed airline mecanic , I have license to work on piston,turboprop, and jet engine but ive always been curious about the rotary engine so I went and bought myself an rx7 fd3s 1995.
I imported the fd from japan bone stock ended up blowing the front rotor apex seals and since then started modifying my fd....
current setup is:
ra superseals with cryo side seals, cryo solid corner seals
busy overhauling the engine myself and doing a half bridgeport
other mods:
T70 turbo,power fc , hks twinpower, act stage 3 clutch, walbro 400lph pump,innovate wideband, oil catch tank, 4inch godspeed intercooler, 3row radiator etc
looking forward to run 12 psi with stock injectors for now, any comments or questions feel free to ask !!
I'm a licensed airline mecanic , I have license to work on piston,turboprop, and jet engine but ive always been curious about the rotary engine so I went and bought myself an rx7 fd3s 1995.
I imported the fd from japan bone stock ended up blowing the front rotor apex seals and since then started modifying my fd....
current setup is:
ra superseals with cryo side seals, cryo solid corner seals
busy overhauling the engine myself and doing a half bridgeport
other mods:
T70 turbo,power fc , hks twinpower, act stage 3 clutch, walbro 400lph pump,innovate wideband, oil catch tank, 4inch godspeed intercooler, 3row radiator etc
looking forward to run 12 psi with stock injectors for now, any comments or questions feel free to ask !!
Last edited by misterstyx69; 11-17-12 at 04:35 PM.
Thread
Thread Starter
Forum
Replies
Last Post