Hey, I'm Joe,

I just got a normally aspirated 87 rx-7 I'm new to rotary and I am just trying to learn.
I actually need a little guidance if anyone more experienced is willing to help. I bought an FC that has a loss of power I mean she just falls on her face after 1500 RPM. I was told the compression is good which means the apex rings should be but if you have any friendly advice it is gladly appreciated.

 

Joe, Washington has a good rotary presence so I'm pretty sure you're going to get the help you need once a few Washington state members check in on this thread. Read up on the posting rules for the new members seen at the top of this page and then head over to the NW regional board once you've got the legit post count to see and participate. You'll run into a lot of rotary nutz there, I guarantee it.

Thanks for taking the time to register and welcome aboard to RX-7 Club!

Mario III