Intro from Orangeville Ontario
#1
noagenda
Thread Starter
Join Date: Sep 2010
Location: Ontario
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Intro from Orangeville Ontario
Hey all
Names Scott
Not a RX7 owner yet but I'm looking really hard.
I'm currently a RX8 owner and I'm looking for another project.
So I'll be lurking around the forum trying to brush up on the tech side of things.
My current rotary is a boosted rensis using a top mount design with a T04e-60 with a FMIC
I run about 11 psi
I'm able to flow about 380 g/s across the Maf in a draw thru setup.
I tuned and installed the turbo myself however I did not do the manifold or downpipe fabrication/design
I know there are big differences between the 8's and the 7's sooooo yeah I'll be mostly lurking/reading
The goal is to be able tune ... something I don't know yet
So back to searching I go!
Cheers
Names Scott
Not a RX7 owner yet but I'm looking really hard.
I'm currently a RX8 owner and I'm looking for another project.
So I'll be lurking around the forum trying to brush up on the tech side of things.
My current rotary is a boosted rensis using a top mount design with a T04e-60 with a FMIC
I run about 11 psi
I'm able to flow about 380 g/s across the Maf in a draw thru setup.
I tuned and installed the turbo myself however I did not do the manifold or downpipe fabrication/design
I know there are big differences between the 8's and the 7's sooooo yeah I'll be mostly lurking/reading
The goal is to be able tune ... something I don't know yet
So back to searching I go!
Cheers
#2
Retired Moderator, RIP
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
Hi Scott!
there is an Engine management section pertaining to different types of ECU's.
maybe check that out.
Check out the CDN section too..(free bacon.today only..lol!)
there is an Engine management section pertaining to different types of ECU's.
maybe check that out.
Check out the CDN section too..(free bacon.today only..lol!)
#5
Rotorless
iTrader: (11)
Scott, glad you made it to the forum finally. Got to get together in the spring. Doug and Glen were over at my place yesterday installing new brake rotors and pads after I rebuilt my calipers on the FD.
Always forget to invite you at the same time for beers & turning wrenchs.
Welcome
Always forget to invite you at the same time for beers & turning wrenchs.
Welcome
Thread
Thread Starter
Forum
Replies
Last Post