Hello from OH
#1
Junior Member
Thread Starter
Join Date: May 2013
Location: Cincinnati
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Hello from OH
Thought I'd say hi and welcome myself to the forums. My name is Paxton and this is my first time working on an RX7. The unfortunate part is that it's not even mine lol. A good friend of mine bought it with me in mind knowing that if anything went wrong I could figure it out... Well he blew it up. 400 whp on stock twins and it seems like it leaned out and took the whole front rotor and housing with it. Fortunately the RX7 store is helping us out with the car.
I've already gained a bunch of knowledge from this forum over the past couple days and plan on learning much more from you guys.
-Paxton
I've already gained a bunch of knowledge from this forum over the past couple days and plan on learning much more from you guys.
-Paxton
#2
80's vibes
iTrader: (1)
Hi Paxton, welcome to the board.
Quite the story there man. Did you get a look at the car before he bought it? (or shortly after?) Or did he really just buy the car, uninterested in its condition because he's got a mechanic like you on hand. I'd feel used if that were the case haha
anyways, again; welcome man, enjoy your stay!
Quite the story there man. Did you get a look at the car before he bought it? (or shortly after?) Or did he really just buy the car, uninterested in its condition because he's got a mechanic like you on hand. I'd feel used if that were the case haha
anyways, again; welcome man, enjoy your stay!
#3
Junior Member
Thread Starter
Join Date: May 2013
Location: Cincinnati
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
He had it for about 2 weeks and was in the middle of a pull and bam...one seal on the front rotor just blew into pieces. I don't feel used by any means because he's paying me, but I get to drive from time to time .
I talked him into going big single, full race twin scroll manifold w/ a borg warner s362 .91. He want's 500+ haha. Guess you could say this has definitely been a learning experience. I've build nissans, toyotas, mitsu's etc. Never a rotary though. Wish me luck!