R1_stormrider

well im not exactly new. i have been lurking here for many years researching information as well as going through the FAQs for stuff. i used this forum to become educated with the FD before i bought it back in '07. so out of the lurker's shadow i come. if you want to see my car please go here:

*******************************/rotary_forum/showthread.php?t=10515


mods are as follows:

3mm Apex seals
monster intake ports
steel thermal pellets
steel corner buttons
850cc/1680cc primary/secondary
Aluminum AST
ACT 6 puck clutch
LS2 coils from Haltech
Aeromotive FPR + gauge
Precision 6262 T4 .81 A/R billet turbo 62 trim
AFX Powerdex Wideband o2 kit w/ NGK sensor (or was it NTK?)
TiAL BOV 50mm
TiAL wastegate 44mm
3" downpipe
HKS manifold
FMIC <-- unsure of brand, came with car. looks knock-offish but works!
aluminum radiator <--- also looks like a knock off that came with car. may replace
Greddy elbow
Haltech PS 1000 stand alone ECU
Alky Control Methanol Injection kit <--- thank you howard coleman for inspiration!
4 gallon fuel cell in the trunk
fuel surge tank also in trunk
rear battery mount
Stance GR+ coilovers 10k front/rear
Yokohama ADVAN 245/45/16 rear
Yokohama ES100 225/55/16 front

those are all the mods that have been done to the car for the past 2 years. its been a work in progress. im currently awaiting the next tuning session so i can take it to the dyno. ill post up the numbers when i can. thanks for reading!

R1_stormrider

tried to post link to the other forum. so nevermind, apparently rotary car club isnt liked here lol.

adracer

Heckuva list you've got there! Looking forward to a photo or two if you can post 'em up. I agree with you on "learning while lurking." There's a lot to consider before pulling the trigger on any one piece of equipment.

How do you like the ACT six-puck clutch? Did you buy it as a complete kit (throwout bearing, etc.), and does it maintain a nice, firm clutch pedal? It is one of the clutches high on my list.

kron17

iTrader: (1)

Cool story. Nice car!!!!