'87 fc3s
06-13-11, 08:06 PM
#1
Full Member
Thread Starter
Join Date: Jun 2011
Location: Pittsburgh, PA
Posts: 82
Likes: 0
Received 0 Likes
on
0 Posts
'87 fc3s
Hi everyone my name is Devon and I live near Pittsburgh. I picked up my FC late last summer and have been reading RX7 club almost non-stop since then. I thought I would finally register on here to get advice and share my own experiences on this huge RX7 online community.
06-15-11, 10:43 AM
#3
Full Member
Thread Starter
Join Date: Jun 2011
Location: Pittsburgh, PA
Posts: 82
Likes: 0
Received 0 Likes
on
0 Posts
These were taken in December. Pittsburgh is so depressing in the winter 
I need to take some more recent pics. the car is not level and rad hose was leaking both of which I have fixed since then. I plan on building a drift car, so far I have PBM coilovers, new rotors and pads all around, new K&N air filter, mazdatrix rear camber bar, and enkei 92 mesh from ebay 15x7 +0 all around (I'm looking for a set of 15x8 -10 for the rear).
I need to take some more recent pics. the car is not level and rad hose was leaking both of which I have fixed since then. I plan on building a drift car, so far I have PBM coilovers, new rotors and pads all around, new K&N air filter, mazdatrix rear camber bar, and enkei 92 mesh from ebay 15x7 +0 all around (I'm looking for a set of 15x8 -10 for the rear).
Thread
Thread Starter
Forum
Replies
Last Post
befarrer
Adaptronic Engine Mgmt - AUS
3
09-22-15 09:33 AM
