82 rx7
#2
Administrator
iTrader: (8)
Join Date: Nov 1998
Location: So. Arlington, TX!!!
Posts: 12,974
Likes: 0
Received 59 Likes
on
36 Posts
An electric fan and then a good exhaust system are good, relatively cheap first timer mods that will reward your efforts quite well.
Welcome aboard, Mark! The more 1stgen guys joining the board, the better, sez I!
Mario III
Welcome aboard, Mark! The more 1stgen guys joining the board, the better, sez I!
Mario III
#3
Rotary Enthusiast
iTrader: (26)
Factory 4barrell came with only two operable.
There is a lever with a spring and a T-top on the stock carb that, when delivered new from the factory, was set so only two of the four barrels worked. The dealership used to charge $85 to modify it so that all four barrels worked. A needle nosed plier and 10 seconds could save you $85 if you knew "the secret". Grab the top of the lever/plunger, near the T. Pull up; hook the "T" on to the arm a few inches above it. The secondaries are now operable.
Bob
Thread
Thread Starter
Forum
Replies
Last Post