Will my rims for Pettit flares work with Feed Flares
Thread Starter
Rotary Freak
Joined: Jan 2002
Posts: 2,360
Likes: 0
From: Overland Park, KS
Will my rims for Pettit flares work with Feed Flares
I'm thinking about switching but I'm worried the Feed flares just wont be wide enough. My rim size is 18x12 with a +18 offset. Any info would be great.
No, according to Shine's measurements, the FEED rear fenders adds 20mm.
https://www.rx7club.com/group-buy-center-69/fd3s-feed-type-front-rear-fenders-584238/
The Pettit flares were apprximately 2-1/4" (57mm-ish) IIRC when I measured the set I had.
I know that 18x12 +18 would have been near dead flush with the Pettits; it'll stick out with the FEED.
https://www.rx7club.com/group-buy-center-69/fd3s-feed-type-front-rear-fenders-584238/
The Pettit flares were apprximately 2-1/4" (57mm-ish) IIRC when I measured the set I had.
I know that 18x12 +18 would have been near dead flush with the Pettits; it'll stick out with the FEED.
I agree with dclin.
Luke you have your wheels about flush with the Pettit rears fenders. There is no way you'll get those under the Feed rear fenders without looking like some Pimp My Ride car.
Luke you have your wheels about flush with the Pettit rears fenders. There is no way you'll get those under the Feed rear fenders without looking like some Pimp My Ride car.
Thread
Thread Starter
Forum
Replies
Last Post
MILOS7
3rd Generation Specific (1993-2002)
10
Aug 19, 2015 07:25 AM
