anyone know where i could purchase the MazdaSpeed smoked combo light covers for a replica GTC front bumper???

 

I heard Pettit makes their own for their own GTC replicas but i can't comfirm that. Give em a call and let us know The only way i hear of getting them is buy actually buying the GTC bumper. I remember Damian got a hold of some, maybe you should PM him.

 

well, i don't have the bumper yet, i'm just trying to figure out where to get stuff thanks man. i guess i'll just look around better later on.

oh, the picture was for demonstration purposes only, its not my car

 

I searched a while on here and found that most people say you can only get them with the front bumper from mazdaspeed, but I found one old post that said rotary extreme was going to be making them. The guy (chuck from rotary extreme) in the post said "we'll have those in about a month" But I couldn't find any on the RE website. Any body know? Chuck? I tried making some myself but I just couldn't get the corner edges in quite perfect enough for my satisfaction, and then as I kept heating up the plexi and pushing to bend it...CRACK. So I just gave up. I'm interested in buying a set too

 

https://www.rx7club.com/showthread.p...C+light+covers

Here is Damian's post and where it was found...very expensive...

 

I got creative and made my own. Cost me less than $20.00.

 

pics?

 

How'd you do it t-von, I'd like to see some pics too or at least a little write up on how it was done. I tried doing everything by hand but it just takes so long.

 

Got any pics

 

If you have a picture for us that will be a good demo for every one to make their own

 

Will post pics tomorrow!

 

As promised.


I've decided to do a write-up on how to make these. Please bare with me because it may take a while because I've been very busy lately. By the way, it wasn't hard at all to make these. It just takes some time to get the templet just right.

 

Looks Good

 

Looks awesome man

 

wow looks pretty good, I'm assuming you used a heat gun to bend acrylic? Well done though, I would only be concerned about moisture getting under the acrylic.

 

Just get some of that very thin adhesive foam weatherstriping for doors, etc. Should be ok as long as you dont blast it with a pressure washer. In that case, there should be some adhesive rubber piping....havent found any yet

 

Let's get the write up!!!

 

no write up coming?

 

Don't worry guys, I haven't forgotten! Like I said before, Ive been very busy. Also for me to do a proper write-up, I would need to remake my own covers and display pics of the process.

 

bump for a write-up... cmon!

 

^^

write up........please

 

Look for it sometime this week. I promise!

 

thanks

 

i just wanted to mention i am having molds made from mine, so i may have some available soon, however i realy like how t-vons came out, looking forward to see the how to write up, i was goin to try to make my own out of lexan, however the compunds bends are beyond me.

 

thanks damian that would be realy cool....keep us posted on them