Whats involved in a paint job
#1
Senior Member
Thread Starter
iTrader: (2)
Join Date: Feb 2003
Location: Kingston Ontario
Posts: 719
Likes: 0
Received 0 Likes
on
0 Posts
Whats involved in a paint job
Whats involved in painting a car its a 84 GS, im talking prepwise, my buddy said he would spray it but i gotta do some prepwork first. I was thinking I gotta sand the old paint off, which is flaking a little. What grits would I use. What would need to be removed? What would I mask up?
#2
Banned. I got OWNED!!!
Join Date: Jun 2003
Location: Broadview Hts., Ohio
Posts: 291
Likes: 0
Received 0 Likes
on
0 Posts
finally my subject area. Mask everything and remove all the moldings... Used a 24 grit to take it all the way to the metal, and then an 80 grit to scuff the metal. Pound the dents out, and hope you dont have ot fill anything. Hope this helps. could always take it to a body shop to get it done. my dad taught me.
#3
Senior Member
Thread Starter
iTrader: (2)
Join Date: Feb 2003
Location: Kingston Ontario
Posts: 719
Likes: 0
Received 0 Likes
on
0 Posts
how much sandpaper would I need and is ther any spacific pattern that I would use. so 24 grit to take off all the paint and then 80 to skuff er up, then prime then metalic then gloss right.... then hunnies rockin the 2 seater up n down up n down.
#4
Full Member
Join Date: Mar 2001
Location: Dallas, Texas USA
Posts: 140
Likes: 0
Received 0 Likes
on
0 Posts
Unless you really know how to do it right, the alternative method has three basic steps:
1. Drive car to body shop.
2. Leave car at body shop.
3. Pick car up after it's done.
Seriously, though, you're flirting with trouble if you don't know what you're doing. It's not as simple as a lot of people think. You have to have the right equipment, the right chemicals and the right environment to do the job. Those who have spoken about doing it themselves either knew exactly what was going on or they did the job and will experience paint problems down the road.
1. Drive car to body shop.
2. Leave car at body shop.
3. Pick car up after it's done.
Seriously, though, you're flirting with trouble if you don't know what you're doing. It's not as simple as a lot of people think. You have to have the right equipment, the right chemicals and the right environment to do the job. Those who have spoken about doing it themselves either knew exactly what was going on or they did the job and will experience paint problems down the road.
Last edited by attomica; 08-21-03 at 02:53 PM.
Thread
Thread Starter
Forum
Replies
Last Post