undress the seat
#1
NAN777
Thread Starter
Join Date: Oct 2005
Location: Malaysia
Posts: 369
Likes: 0
Received 0 Likes
on
0 Posts
undress the seat
hi guys...
does anyone have the direction to undress the original FD3S seats ?
my leather is going to the bin... i need to take it out to redo the leather....
any advise? i can't find any detail from the workshop manual or body manual or any manual....
does anyone have the direction to undress the original FD3S seats ?
my leather is going to the bin... i need to take it out to redo the leather....
any advise? i can't find any detail from the workshop manual or body manual or any manual....
#4
Rotary Enthusiast
iTrader: (4)
I just took the leather off of the lower part that you sit on to remove a bunch of the foam to have a lower seating position. There are a bunch of brass or copper wires that secure the leather to the rest of the seat. With a pair of pliers you can bend them open to release and then re-use them when you put it back together, I had no issues bending mine back after I was done cutting the foam. Didnt mess with the back part but I would assume its similar. The only other part was a couple of those plastic push in things like other parts of the interior.
#6
93 Touring
This link takes you to step by step seat leather removal with pictures.
http://www.leatherseats.com/RX7_installation_guide1.asp
http://www.leatherseats.com/RX7_installation_guide1.asp
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM