Stock FD R1 radio cutting in & out
Thread Starter
Joined: Mar 2006
Posts: 9,789
Likes: 810
From: Bay Area CA
Stock FD R1 radio cutting in & out
Problem started suddenly a few days ago. Its the original stereo in my R1. After a few minutes of listening to the radio, all of a sudden the sound starts cutting in/out very quickly.
Alternator Voltage is fine on the car.
Is this the head unit going out or an amp? Does this stereo system have an amp?
Thanks.
Alternator Voltage is fine on the car.
Is this the head unit going out or an amp? Does this stereo system have an amp?
Thanks.
Thread Starter
Joined: Mar 2006
Posts: 9,789
Likes: 810
From: Bay Area CA
Non bose single din system with fancy casette tape play vintage 1993 
I think I'm going to get a decent Alpine and try to figure out how to install this. I suck at stereo stuff and wiring.

I think I'm going to get a decent Alpine and try to figure out how to install this. I suck at stereo stuff and wiring.
Its easy. If you just had a cassette player and the sound was going up and down on the cassette only it could be the heads going bad.
For installation you just use "ford keys", or some use coat hangers in order to remove the factory radio. Then use a metra harness, I think mazda's are 70-7901 but you can have BB, CC, or crutchfield look it up and buy if from there. Then you match colors to colors from your new radio to the harness, and the harness clips in and your done. No cutting required.
For installation you just use "ford keys", or some use coat hangers in order to remove the factory radio. Then use a metra harness, I think mazda's are 70-7901 but you can have BB, CC, or crutchfield look it up and buy if from there. Then you match colors to colors from your new radio to the harness, and the harness clips in and your done. No cutting required.
when you turn your key on and the radio comes on does a speaker pop? a speaker grounding out is a posibility but if it doesnt do it until its been playing for a while it is prolly the radio
Thread Starter
Joined: Mar 2006
Posts: 9,789
Likes: 810
From: Bay Area CA
No, it doesn't pop. It works OK when I turn on the radio and then starts cutting out after a few minutes of use.
I'll probably go aftermarket one of these days.
I'll probably go aftermarket one of these days.
Thread
Thread Starter
Forum
Replies
Last Post
armans
3rd Generation Specific (1993-2002)
5
Aug 15, 2015 09:08 PM







