I have had a hell of a week. I am looking to restore my interior and at the same time clean up the wiring mess that the previous owner of my car did.

The stereo that was in the car worked, but I wanted to rid myself of the double din deck and just have a single din, something simple.

So I had the interior (tan to black) done, and the old deck was pulled out, and wires were not exactly kept track of.

I have figured out the passenger side door speaker got it to work. I have found the power line (Constant 12v) but have been unable to find the ACC power (for when you do not start the car), and also wanted to confirm the colors of the wires for the driver side door speaker?

Any information would be great. I have looked at the chart, and searched around. I only post because I have yet to find the solution.

Thank you,

real1st

 

Which car?

 

93 fd

 

I hope this information isn't too late. Please verify with a multimeter if you have one/know how to use one.

Accessory 12 Volt
BU/BK

Constant 12 Volt
BU/RD

Chassis Ground
BK*

Power Antenna
GN/OG

Remote
L.GN/BK

Illumination
RD/BK

Dimmer
RD/GN

Left Front Spkr +
GN

Left Front Spkr -
BU

Right Front Spkr +
RD

Right Front Spkr -
WT

Left Rear Spkr +
YW/GN

Left Rear Spkr -
YW/BU

Right Rear Spkr +
WT/BU

Right Rear Spkr -
BU/YW
__________________________________________________ _______________
FUSES

15 AMP
"CIGAR"
DRIVER'S SIDE DASH PANEL

10 AMP
"ROOM"
DRIVER'S SIDE DASH PANEL

__________________________________________________ _______________
The vehicle has a center speaker and a center speaker amplifier. The amp accepts speaker level inputs that are wired in parallel with the front speakers. The amp receives its turn-on signals from the power antenna lead, pin #7 (1993 model year only) and the amp remote wire, pin #10. When installing an aftermarket stereo, wire the speakers normally and connect both the power antenna wire and the amp remote wire (use only the amp remote wire for 1994-96 model years).