I have a component system that I am putting in my fc. I have already mounted the tweeters on the upper door panel and I am debating on whether to install my 4" above the power window switches, I beleive there is already a pre cut hole behind this area or down next to my feet in the bottom of the door panel, where I will have to do some cutting, any thoughts or ideas?

 

https://www.rx7club.com/forum/showth...&threadid=9211

 

excellent, that is what i was going off, did you just drill straight through the panel and particle board?

 

also should I build an enclosure for the woofer or leave it flowing free air?

 

I cut holes through the door panel and mounted everything with T bolt screws.

Definately build a proper box for your sub.

 

not for the sub for the 4" woofer