Interior / Exterior / Audio Talk about interior and exterior mods including audio.

Need help mounting S5 Fog lights...

Thread Tools
 
Search this Thread
 
Old May 29, 2010 | 11:47 PM
  #1  
elmayimbe4eva27's Avatar
Thread Starter
Senior Member
iTrader: (2)
 
Joined: Sep 2009
Posts: 410
Likes: 0
From: Corona, NY
Need help mounting S5 Fog lights...

Hello, so i purchased a set of S5 fog lights from a member on here but when i received it, it had no mounting brackets, so i have no idea how i'll be installing them. Does anyone have any idea how i can mount them to my bumper? Any suggestion will help thanks!
Reply
Old Jun 3, 2010 | 11:13 PM
  #2  
Ning's Avatar
Junior Member
 
Joined: Jun 2010
Posts: 2
Likes: 0
From: Under The Bonnet Of My Car
Here are the steps to follow:

Step 1

Purchase materials. If replacing existing units, skip steps 4-10.

Step 2

Remove the lights from the box and check the amp rating. Purchase a switch with a high enough rating. If a switch of equal or higher ratings can't be found, you will need to get a relay (see below).

Step 3

Use the brackets to mount lights in the desired location.

Step 4

Locate a secure, easy to reach place in the car to mount the switch for the lights.

Step 5

Mount the switch in the vehicle.

Step 6

Locate a source of power under the hood that does not directly attach the wires to the battery. (On some vehicles, the headlight circuit may do.)

Step 7

If you found a switch of the needed rating above, connect source to switch, switch to lights, lights to source, then skip to step 11.

Step 8

If you are using a relay, then mount the relay somewhere secure under the hood.

Step 9

Attach the Light circuit to the "Load" side of the relay. Run wire from power source's Hot supply to one of the relays load terminals. Connect the relays other load terminal to the light closest to it. Connect the remaining connection on the light to one of the connections on the other light. Connect the second light's remaining connection to the negative side of the power source.

Step 10

Connect the switch. Run wire from a power source to one of the "Control" terminals on the relay. Connect the other terminal to the switch. Connect the remaining switch terminal to the negative of the power source.

Step 11

Install bulbs.

Step 12

Start car and test. If selected sources fuse blows, replace and try connecting to another source.

Step 13

Proceed if it all works. If not, check connections.

Step 14

Cover all joints with electrical tape to ensure weatherproofing.

Step 15

Now go drive in style...

Good Luck
Reply
Old Jun 4, 2010 | 11:57 AM
  #3  
elmayimbe4eva27's Avatar
Thread Starter
Senior Member
iTrader: (2)
 
Joined: Sep 2009
Posts: 410
Likes: 0
From: Corona, NY
Thanks for the write up but, where do i find the brackets? I don't have any, the fogs didn't come with them. It seems like it was broken off.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
freq
2nd Generation Specific (1986-1992)
4
Sep 7, 2015 04:35 PM
SakeBomb Garage
SakeBomb Garage
0
Sep 4, 2015 05:20 PM
SakeBomb Garage
Vendor Classifieds
0
Sep 4, 2015 05:19 PM




All times are GMT -5. The time now is 09:57 PM.