Icemark or anyone with factory security experience
#1
Icemark or anyone with factory security experience
Ok when I added the keyless entry to the factory alarm system. I used the unlock (-) to disarm the factory alarm. And the lock (-) to set the factory alarm. I diode isolated both (-) trigger wires , just in case of whatever. But the factory alarm on my car will only arm when the door is open (IE locking it manually or with the keyless entry when the door is open and then shutting the door arms the factory alarm) You know of another way to arm the factory alarm w/o opening the door? See the problem is when I exit and lock it , it sets, but if i press unlock then I have to go back open the door rearm it and then shut the door. Thanks
#2
Former Moderator. RIP Icemark.
Same idea as your dis-arm. "T" off of the door lock wire to a realy that pulses the door trigger wire. This should trick the factory alarm to thinking the door is open at the same time.
You might want to use a second relay off of the ignition that interupts the above mentioned door trigger relay, if you have ignition controlled door locks. The idea with the relay triggered off ignition is so that the door trigger/arm relay doesn't flash the dome lights when the doors lock when the key gets turned on.
If you need a slightly longer delay to the door trigger pulse while arming try using a 100Mfd polar cap across the 85, 86 leads of the door trigger relay.
You might want to use a second relay off of the ignition that interupts the above mentioned door trigger relay, if you have ignition controlled door locks. The idea with the relay triggered off ignition is so that the door trigger/arm relay doesn't flash the dome lights when the doors lock when the key gets turned on.
If you need a slightly longer delay to the door trigger pulse while arming try using a 100Mfd polar cap across the 85, 86 leads of the door trigger relay.
#3
Thanks Icemark... Man you pretty good on those alarms. What I tried was a long shot and it work, I just hooked up the dome light surveliance wire to the blue/white (if I remember right) at the theft control module and it freaking work. I thought maybe it would be to quick for it to catch it. But anyways, thanks man!
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
AMOC
SE RX-7 Forum
1
09-10-15 09:42 AM