Interior / Exterior / Audio Talk about interior and exterior mods including audio.

How to get rear speakers out of FD?

Thread Tools
 
Search this Thread
 
Old Jan 29, 2004 | 09:30 AM
  #1  
CSMCanuck's Avatar
Thread Starter
Senior Member
Tenured Member 15 Years
 
Joined: Oct 2003
Posts: 344
Likes: 0
From: Calgary, Canada
How to get rear speakers out of FD?

I search but couldn't find any info on how to get my rear panals off to get at the rear speakers.

Any help would be appreciated.
Reply
Old Jan 29, 2004 | 10:04 AM
  #2  
jdhuegel1's Avatar
Glug Glug Glug Burp
Tenured Member 05 Years
 
Joined: Jan 2002
Posts: 3,819
Likes: 0
From: Scott AFB, IL
They are clipped in. Just take the door seal off, get your fingers behind the panel and pop the panel off.
Reply
Old Jan 29, 2004 | 10:12 AM
  #3  
David Beale's Avatar
Senior Member
Tenured Member 05 Years
 
Joined: Jun 2003
Posts: 617
Likes: 0
From: Edmonton Alberta Canada
I think if you just pry off the grills you can also get the speakers out. There are screws to get the interior rear quarter panels out. There is one or two down behind the seat on/by the door sill (don't remember exactly, just look before pulling). The panel does pop out, just be careful to work each clip (I use a panel tool - large bent slot screwdriver tip with a slot cut in it). You may have to straighten or replace some of the clips before putting the panel back.
Reply
Old Jan 29, 2004 | 08:58 PM
  #4  
bajaman's Avatar
Constant threat
Tenured Member 20 Years
 
Joined: Jul 2001
Posts: 4,968
Likes: 39
From: near Wichita, Kansas
Take the plastic panels out. Do NOT try and pry the speaker grille panels off, you will just break them.
There are just a few screws to take out to get the panels off, and also take off your trim molding around the doors.
Reply
Old Jan 29, 2004 | 09:25 PM
  #5  
rynberg's Avatar
Lives on the Forum
Tenured Member: 20 Years
 
Joined: Dec 2001
Posts: 14,716
Likes: 10
From: San Lorenzo, California
http://www.maxcooper.com/rx7/how-to/...ers/index.html
Reply
Old Jan 29, 2004 | 10:19 PM
  #6  
InsaneGideon's Avatar
Still on 1st engine
Tenured Member 05 Years
 
Joined: Jun 2003
Posts: 1,176
Likes: 1
From: SoCal
...and they'll never go back the same again. Damn plastic!

Last edited by InsaneGideon; Jan 29, 2004 at 10:23 PM.
Reply




All times are GMT -5. The time now is 12:15 PM.