FD Drilled Aluminum Brake pedal for Auto trans
#1
FD Drilled Aluminum Brake pedal for Auto trans
I finally got off my *** & manufactured a drilled/dimpled aluminum brake pedal for all you Auto FD owners.
It's based on my drilled/dimpled aluminum dead pedal design.
Easy to install, no drilling required. Just remove the rubber cover & screw the aluminum cover over the stock pedal.
IM going to offer the 3 piece set (dead, gas & brake) for $100. Check out the post in the 3rd Gen "Parts for Sale" section for ordering info.
THX,
It's based on my drilled/dimpled aluminum dead pedal design.
Easy to install, no drilling required. Just remove the rubber cover & screw the aluminum cover over the stock pedal.
IM going to offer the 3 piece set (dead, gas & brake) for $100. Check out the post in the 3rd Gen "Parts for Sale" section for ordering info.
THX,
Thread
Thread Starter
Forum
Replies
Last Post
CaptainKRM
2nd Generation Specific (1986-1992)
14
08-26-15 09:52 PM