Which Bride Seats Fit For Fd?
04-24-05, 03:48 PM
#27
Rotary Freak
Corsa will NOT fit as you need the OEM slide rails for fitment and the inner seatbelt lugnut is in the way and needs to be removed. Other than that youhave VERY little space left in the headsection area of the seat towards the roof.
If you don't worry about hacking up your slide they may fit but not without.
Considering the side section of the seats being as high as the mid tunnel it wil also limit the possibility of moving the seat front to back.
I have started my own projectwith a fiberglass seating piece (due to a mold made from the OEM seat shell) and the back of a Sparco Corsa seat. A blend of both will insure perfect fitment to the OEm rails and the ****** of the Corsa seat..
If you don't worry about hacking up your slide they may fit but not without.
Considering the side section of the seats being as high as the mid tunnel it wil also limit the possibility of moving the seat front to back.
I have started my own projectwith a fiberglass seating piece (due to a mold made from the OEM seat shell) and the back of a Sparco Corsa seat. A blend of both will insure perfect fitment to the OEm rails and the ****** of the Corsa seat..
The following users liked this post:
smoke wagon (08-23-20)
09-25-07, 04:35 PM
#29
Senior Member
Join Date: Apr 2007
Location: Northern Virginia
Posts: 677
Likes: 0
Received 0 Likes
on
0 Posts
For Bride, the best options for trouble-free fitment in an FD would be:
non-reclining: Exas III, Pros, Zeta III Type S
reclining: Brix II, XaX II
Bodyshop: You had to remove the reclining ****? Does that mean you can't recline the seat at wall or is it just really difficult? Hmmm..is the seat mounted all away against the tranny tunnel?
That's a good reason to get the Bride brackets - they place the seat properly so it should fit.
non-reclining: Exas III, Pros, Zeta III Type S
reclining: Brix II, XaX II
Bodyshop: You had to remove the reclining ****? Does that mean you can't recline the seat at wall or is it just really difficult? Hmmm..is the seat mounted all away against the tranny tunnel?
That's a good reason to get the Bride brackets - they place the seat properly so it should fit.
This guy could not get them to fit into his FD without removing the door panels:
https://www.rx7club.com/showthread.p...t=bride+brix+2
Thread
Thread Starter
Forum
Replies
Last Post
