anyone replaced a93-95 rear quarter panel?
#1
Rotary Enthusiast
Thread Starter
iTrader: (1)
Join Date: May 2003
Location: Dallas
Posts: 1,464
Likes: 0
Received 0 Likes
on
0 Posts
anyone replaced a93-95 rear quarter panel?
i need to replace my passenger side rear quarter panel.
apparently this is welded in.
has anyone replaced it with a used one?
will the previous weld cause problems installing that would require extensive labor?
also been thinking about the knightsport fenders
or the GTC fenders
im not sure if that would cover the whole pannel dingies
this is the 2nd time the car was hit in the same spot within 6 months. apparently people see red and get dazed and then oops!
apparently this is welded in.
has anyone replaced it with a used one?
will the previous weld cause problems installing that would require extensive labor?
also been thinking about the knightsport fenders
or the GTC fenders
im not sure if that would cover the whole pannel dingies
this is the 2nd time the car was hit in the same spot within 6 months. apparently people see red and get dazed and then oops!
#3
Senior Member
Join Date: May 2003
Location: San Francisco, CA
Posts: 517
Likes: 0
Received 0 Likes
on
0 Posts
i dunno where exactly your 1/4 panel got bump into, but if u going to put the GTC fender flare on, i think the stock fender will crack even u pull out thoz dent.
am i talkin on da rite stuff
am i talkin on da rite stuff