99 jspec lip,weather striping peeling
#1
Full Member
Thread Starter
Join Date: Sep 2001
Location: Maryland
Posts: 165
Likes: 0
Received 0 Likes
on
0 Posts
99 jspec lip,weather striping peeling
Hey just looking fro some advice. I could not find a thread about this but I think I saw one a few months ago. I juts came back from the shore and the rubber strip on the front of the 99 spec lip has all but peeled off. When I purchased it from thrt RX7 Store it already was lifting in a few areas .Since it dragged I need to repalce it ( I think I have seen a strip of rubber at Home Depot)However I dont know what type of adhesive to secure it on better than the factory did . Send me the link to the thread or let me know ehat you tried.Thanks
94 touring ,99 jspec lip, rear wing,PFS intercooler,air box,exhaust
94 touring ,99 jspec lip, rear wing,PFS intercooler,air box,exhaust
#5
Full Member
Join Date: Sep 2001
Location: EVERYWHERE
Posts: 222
Likes: 0
Received 0 Likes
on
0 Posts
hey turbotime, don't forget to turn on your lights when driving at night. You might be able see a little better. Sorry man, had to get it out... good luck repairing your lip.
see ya,
car 53
see ya,
car 53
#7
Fast Forward
iTrader: (1)
Having the same problem myself. Looked at several stores... Home Depot, and Lowes and couldn't find any replacement strip. Actually... it seems like there was some pretty decent adhesive on there for it just to be protecting the edge. I think it's to keep it from permanantly gashing up the front... of course. Once you tear the rubber - it looks even worse.
Maybe I'll just remove it.
Maybe I'll just remove it.
Thread
Thread Starter
Forum
Replies
Last Post
killerrx710
Adaptronic Engine Mgmt - AUS
5
09-28-15 09:13 AM
killerrx710
2nd Generation Specific (1986-1992)
1
09-24-15 10:57 PM