90mm Dual Beam Wiring Help
#1
ReDux
Thread Starter
iTrader: (16)
Join Date: Apr 2005
Location: Woodbridge, VA
Posts: 334
Likes: 0
Received 0 Likes
on
0 Posts
90mm Dual Beam Wiring Help
Okay, so I've acquired some replica KS shrouds and brackets for them.
I purchased some 90mm hella units and am looking for some tech instructions and/or wiring diagram on what splices into what on the stock harness, and if clips are needed.
Will run through the FSM but just need to know basically what wires connect to what so everything functions like OEM. High Beam, low beam.
All suggestions and advice are welcome, thanks.
I purchased some 90mm hella units and am looking for some tech instructions and/or wiring diagram on what splices into what on the stock harness, and if clips are needed.
Will run through the FSM but just need to know basically what wires connect to what so everything functions like OEM. High Beam, low beam.
All suggestions and advice are welcome, thanks.
#3
Rotary Freak
iTrader: (22)
Hey I did this mod manys years ago and it work great, I also brought a ready made upgrade harness from jegs, it's yellow with built relay pretty plug and play it has the adapter to plug into factory harness (headlight plug) and then u run it over to the right side and left then u find a right apporiate plug or another adpater and connect ur hella lights. This way allow u to run the hid and other high power light without burn out the factory harness. T believe the plug from jegs was like $34.00.
Khris
Khris
#4
ReDux
Thread Starter
iTrader: (16)
Join Date: Apr 2005
Location: Woodbridge, VA
Posts: 334
Likes: 0
Received 0 Likes
on
0 Posts
Any idea on the name of this harness you bought from jegs? or what I'm looking for? This would help vary much. Want to retain the OEM fuction and have lights and high beams controlled from the switch on the steering column.
#5
ReDux
Thread Starter
iTrader: (16)
Join Date: Apr 2005
Location: Woodbridge, VA
Posts: 334
Likes: 0
Received 0 Likes
on
0 Posts
Okay so found the upgraded H4 harness and relays but what about the adpater from the H9 bulb connector to the H4 bulb style connector? What are my options here or just solder the wires?
Thread
Thread Starter
Forum
Replies
Last Post
The1Sun
1st Generation Specific (1979-1985)
0
09-07-15 10:21 PM