Haltech wiring up a haltech e8 with OMP and wideband
Thread Starter
Junior Member
Joined: Sep 2004
Posts: 27
Likes: 0
From: Gold Coast, Australia
wiring up a haltech e8 with OMP and wideband
im installing a e8 in a series 5 rx-7 13bt at the moment, and am wanting to use the electric OMP.
does anyone know how to wire/set this up???
i know i need an input with OMP stepper feedback, and you set the rotary OMP stepper motor in the stepper motor options menu in halwin, but how do you wire it up to the OMP unit???
also, can you wire in haltech's wideband 0-5V sensor output into the stock O2 sensor input?? and in the fuel setup select "haltech calibrated sensor on O2 input" with a 5v gain control.
or does this 5v input have to put put into a auxillary input, and select "UEGO sensor input" in the input options?
does anyone know how to wire/set this up???
i know i need an input with OMP stepper feedback, and you set the rotary OMP stepper motor in the stepper motor options menu in halwin, but how do you wire it up to the OMP unit???
also, can you wire in haltech's wideband 0-5V sensor output into the stock O2 sensor input?? and in the fuel setup select "haltech calibrated sensor on O2 input" with a 5v gain control.
or does this 5v input have to put put into a auxillary input, and select "UEGO sensor input" in the input options?
'Tuna'
Joined: Feb 2001
Posts: 4,637
Likes: 3
From: Miami,Fl,USA
Right here---->http://www.k2rd.com/haltech/drawings/OMP03.pdf
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
Sep 16, 2018 07:16 PM
