In wiring the injectors there are 4 wires. 1 for each injector.
You have INJ1, INJ2, INJ3, INJ4.
They are all powered by one common wire (Red and Yellow)
My question is, the INJ1, INJ2, are primary and the INJ3 and INJ4 are secondary.
Does it matter which one of the primary wires goes to a certain primary injector?
In other words can I wire the INJ1 wire to the Primary 2 injector?
Does it make any difference as long as it's to the primary injector?

 

well, just for my own sanity I would wire them correctly but since they are batched it makes no difference which way you put them in.

 

It does not matter if you are running sequential. Just make sure you have the 1 and 2 injectors as primaries and 3 and 4 as secondaries.

I think this was just covered on the Haltech list.

CosmoDork, are you back in the USA?

 

Sequential? I guess I must be out of it and rusty. I am sure you get the point though

Nah, I am still over in Japan. I am visiting a friend in Kyoto so I am using his DSL access