I'm having trouble locating a couple connectors in the WSM. The blue and white one...

the 1-2 switch connector has 4 wires...one of which is yellow (with gray bands I believe).

the blue and white connector have the same...per installation of E6K on lighteing/world thunder site...it says to cut yellow/gray wire from both blue and white connectors.

Can anyone tell me what this wire does or where to find these connector pin outs in the manual?

TIA


I know this forum doesn't get a lot of views...but hopefully someone can shed some light.

I have ten wires for the 4 connectors on the tranny, and nine total on the blue and white connectors.

 

And what is this for?
I don't usually mess with anything but the main engine harness, and on Zenki FC's, it's only the CAS plug.


-Ted

 

This is for a 5 speed transmission harness for an FD.

4 plugs: Nuetral, 1-2 switch, back up lights, and ??? (****, can't think at the moment...have it written down at home)


step 10 and 11.

http://www.scuderiaciriani.com/rx7/haltech_install.html

 

BTW, I'm installing a E6X.

 

speed sensor is the one I couldn't remember.

 

no one knows why the yellow on the 1-2 switch is cut out of both connectors or what the wire controls?

everyone just cuts the wires and plugs it in?

I like to ask many questions about what I'm doing...

 

haltech reads only speed sensor, and its just for looks, it won't let you datalog it....

the only other one you really need is the backup light, so if your speedo+backup lights work, you're good to go