throttle position senser on page 16 in the book, it has the wires as
(a) ground
(b) signal
(c) +5 volts
by the way the senser looks, the wire colors are
(a) org
(b) green
(c) blk
and on the haltech harness it is
(a) blk
(b) wht
(c) org
so is that the way it is on your car
org (a) to blk
green (b) to wht
blk (c) to org

and for the bar map what are the wire colors for (a) (b) (c) on the haltech harness

thanx, andy

 

it only takes like 2 mins to go to your car and see. this is the only thing keeping me from starting my car.
thanx, andy

 

I'm sorry, but all the Haltech cars I've worked on are THOUSANDS of miles away from me right now.

It only takes a few minutes to check the wiring diagram for the back of the Haltech manual and a DMM to figure out what leads are what.&nbsp If you cannot confirm wire colors, run the wires to pinouts, also labelled in the back of the Haltech manual.


-Ted

 

never mind i got it