Haltech a question about Haltech wiring and fuel injectors
a question about Haltech wiring and fuel injectors
I bought my car (no motor, but I dropped a newly rebuilt one in there) some time ago and it came with a Haltech E6K and a harness already wired up for an S5 RX-7. The harness is out of the car, but I'm nearly ready to install it.
My car is an S4, and I only have S4 turbo injectors, so naturally I'm going to need to splice in the square injector plugs from the S4.
I have 2 sets of stock injectors, the purple top ones and the pink top ones (that have the notch offset on the plug). I also have 2 x 750cc injectors that I intend to use as secondaries; I believe that they are low impedance. They are the PB8X 750 model injectors from RC Engineering.
My question is, since the (stock) S5 harness asks for high impedance injectors, would the Haltech harness be the same, since it's wired for an S5? And if that's the case, will I need to splice in resistors before the plugs if I want to use my 750's?
My car is an S4, and I only have S4 turbo injectors, so naturally I'm going to need to splice in the square injector plugs from the S4.
I have 2 sets of stock injectors, the purple top ones and the pink top ones (that have the notch offset on the plug). I also have 2 x 750cc injectors that I intend to use as secondaries; I believe that they are low impedance. They are the PB8X 750 model injectors from RC Engineering.
My question is, since the (stock) S5 harness asks for high impedance injectors, would the Haltech harness be the same, since it's wired for an S5? And if that's the case, will I need to splice in resistors before the plugs if I want to use my 750's?
