ok.. so i have a 13bre and im having starting issues.. it wont start by itself.. and when i say start by itself is that it wont start inleast i use starting fluid.. and even when it starts with starting fluid the fpr doesnt read pressure.. i have a sard fpr with a jegs fpr gauge.. any input would help alot...

 

Well yeah. You need fuel pressure to run a fuel injected engine. Is your fuel pump wired correct? You should hear it prime with the key to ON.

 

well i dont hear it prime but then i do have fuel going to my fuel rails.. i took the line off and turn the car to the ON possition and it came out.. any help would great at this point... im still stuck

 

it should not just "come out", more like, it should shoot everywhere like an alter boy at a ***** house.

first and foremost. get the fuel pressure issue squared away. it should prime for a couple secconds, then stop. the pressure should hold. if it bleeds off after about 2 minutes, then you have to figure that **** out.

 

ill have to check that tomorrow.. do you guys know any way to clean the injectors without taking it to the shop to get it done..?

 

fuel lines back to front?

pump > fuel rail > FPR > return to tank

the supply pipe is the one with the fuel filter on it ,, tucked at the bottom of the firewall

 

yeup i have it like that.. i just dont know why my car is not running by itself.. im re-looking my wiring again but it is all right.. i dont get. ill just pump my stock fuel pump in to see if that will work...