Haltech Noob first install questions, dire help needed
#1
Junior Member
Thread Starter
Join Date: Nov 2008
Location: rotorland
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
Noob first install questions, dire help needed
Hey guys I'm in the process of fitting a ps1000 to a 1985 rx7 with a 91 s5 13bt motor
I'm using an external 5 bar map sensor, the map sensor came with a small wiring diagram that says pin A is ground, however on the ps1000 main wiring diagram the ground wire for the map sensor and the tps says "to ecu pin b14 black/white wire"
my questions are, what is b14, b11 etc? There is no black/white wire in my loom there is a thick black, a thin black and a black yellow, can I just earth the tps and map on a chassis earth?
I'm using an external 5 bar map sensor, the map sensor came with a small wiring diagram that says pin A is ground, however on the ps1000 main wiring diagram the ground wire for the map sensor and the tps says "to ecu pin b14 black/white wire"
my questions are, what is b14, b11 etc? There is no black/white wire in my loom there is a thick black, a thin black and a black yellow, can I just earth the tps and map on a chassis earth?
#2
Junior Member
Thread Starter
Join Date: Nov 2008
Location: rotorland
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
also, i am using a short loom, no relays and stuff included as i was hoping to patch this directly into the microtech loom alot of time was spent making
is 'b11, b14' a relay(s)?
is 'b11, b14' a relay(s)?
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
12abridgeport
1st Generation Specific (1979-1985)
2
08-17-15 06:28 PM