Hi just got my new motor in my car, And it will not run? Well I have had it to run but
not the way it is suppose to. And when it was runing the turbo would start to
glow in less then 2mins! That seems like the timing. OK whit that said I had to move the crank angle way out to got it to start. and the timing was not zeroed out
So I go and zero the timing and now it will not even fire. I got the yellow crank mark lined up with the pointer on the front cover, and lined up the dot on the crank angle and put it in the motor. So now its in time LOL I put my timing light
on the leading 1 plug and got my friend to spin the motor over. And the line on the crank is showing up at the pointer. So the motor is in time and Im not losing
my mind HAHA. So that just leaves the maping on the E6K.But from what I see it should be runing. So here is how I have the Haltech set up.

Please Help and thanks for reading


Trigger Gain: 2
Home Gain: 2
Trigger Angle: 65
Trigger Type: Multitooth
Number of Teeth: 24
Tooth off Set: 11
Spark Mode: Distributor
Engine Type: Rotary
Output Type: Constant Charge
Coil Charge Time: 4.5mS
Output Edge: Falling
Timing lock: ON
Timing Angle locked at -5

 

Please Help