Haltech Just purchased Haltech Sport 1000
#1
Full Member
Thread Starter
iTrader: (8)
Join Date: Jul 2011
Location: Las Vegas
Posts: 146
Likes: 0
Received 0 Likes
on
0 Posts
Just purchased Haltech Sport 1000
Hey guys i been running power fc and now ive made the switch to haltech sport 1000. I just purchased a used kit off someone that was installed on a scion. Im going through the pinouts on the ecu connectors to see if im missing anything from installing it onto my FD. It came with haltech boost solenoid, haltech single probe egt, and haltech dual sensor wideband controller. I want to make sure everything is installed right with the wiring so any tips for getting all these wired up will help. My main focus is making sure i have all the neccessary wiring since this was installed on a scion. Im going to need to extend the wires since i only have like a 2-3ft pigtail for ecu connectors. Whats a good supply of wire? Ive thought about using mil spec 22759/16 20awg wire. Any thoughts? Any sensors reccomend to replace on the FD? I have a fast reacting iat, and gm 3 bar map sensor already but curious if coolant temp sensor should be replaced? Sorry for all the questions, just a lil overwhelmed and cant wait to start tuning. Id also like to run a fuel pressure sensor for datalogging.
#3
Retired Moderator, RIP
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
You know that C Ludwig on forum here(www.lms-efi.com) could make you a Harness for that?.(plug and play)
Thread
Thread Starter
Forum
Replies
Last Post
SakeBomb Garage
Group Buy & Product Dev. FD RX-7
8
10-09-15 10:05 PM