Haltech Installing the Haltech on a 2 gen
#1
Concerned Citizen
Thread Starter
iTrader: (3)
Join Date: Nov 2001
Location: Miltown, WI
Posts: 699
Likes: 0
Received 0 Likes
on
0 Posts
Installing the Haltech on a 2 gen
Ok. I've got a few questions
-When I install it can i just pull the whole engine harness or does it need to stay? (keep in mind this is a street car so i want wipers and maybe cruise)
- Can i get rid of all those stupid metal vacuum lines if i have no emissions?
-How do i control boost w/ it? Can i control a waste gate?
I may have a few more just can't think of any now. THANKS BYE!
-When I install it can i just pull the whole engine harness or does it need to stay? (keep in mind this is a street car so i want wipers and maybe cruise)
- Can i get rid of all those stupid metal vacuum lines if i have no emissions?
-How do i control boost w/ it? Can i control a waste gate?
I may have a few more just can't think of any now. THANKS BYE!
#2
inteligent extratarestril
Join Date: Mar 2001
Location: The Sunny B.O.P, New Zealand
Posts: 1,313
Likes: 0
Received 0 Likes
on
0 Posts
you wont have the wipers issue in a series 4, that is only in a series 5. In a series 4 you will need to run a wire from the temp sender unit to the dash cluster, that is it. yes you can pull all the steel lines etc, just make sure you dont remove the OMP lines, unless of course you PLAN on removing them (like i did)
yes it can bleed air off going to the wastegate
yes it can bleed air off going to the wastegate
Thread
Thread Starter
Forum
Replies
Last Post
Claudio RX-7
Haltech Forum
5
04-23-19 02:50 PM