mako

iTrader: (5)

I am having a hard time getting my Tach and speedometer to work.

my car runs great right now, I just need to find out where these last few wires need to go.

what is the right wire to hookup for the factory tach?


is it this yellow and blue wire? should it go to 1H on the other yellow connector? I have another wire tied into that point i think to pick up the rpm signal for the haltech.

and also



does this white connector plug in somewhere. i had a white connector and blue connector coming in the car from the tranny. the blue one plugged in, and then the white one pluggs into this extended white harness and does not seem to go anywhere??? did i miss something, i am pretty sure this is why my speedometer does not work. the odometer stays on and the other gauges work but the speedo never moves..

last thing is which wire do I tie into for the low coolant buzzer to shut off.

thanks for any help.
James
mako@nationwide.net

Marcel Burkett

Your speedo would work if you
1 . plug the factory harness back into the tranny where the sensor is .
2 . Cut this part of the harness off , retaining the blue ( white , I cant remember ) connector which should then be plugged into the other matching one which is located behind the blower motor in the passenger area foot well.
3 . A fter doing this you would hahe two grounding ires free , they should be connected to a good ground.There should also be a Hot wire ,I use this to power my BAC valve .

mako

iTrader: (5)

thanks, since my car has been down for so long i did not remember where that white one plugged into. the plug that was behind the blowermotor. my speedo works not, but tach is still not.

this weekend when i have time to look at the car in daylight I will try and get it all sorted out.

James